This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
product:usb2lds:parameters [2014/06/10 23:19] xevel |
product:usb2lds:parameters [2016/09/29 13:11] xevel [Putting the USB2LDS in setup mode] |
||
---|---|---|---|
Line 9: | Line 9: | ||
To set the parameters, the USB2LDS has to be in setup mode. | To set the parameters, the USB2LDS has to be in setup mode. | ||
- | * Start a serial terminal application (like [[http://www.chiark.greenend.org.uk/~sgtatham/putty/!PuTTY]] or Arduino Serial Monitor) | + | * Start a serial terminal application (like [[http://www.putty.org/|PuTTY]] or Arduino Serial Monitor) |
- | * Open the Virtual serial port with a baud rate of //9600// (was //1337// with first protos). | + | * Open the Virtual serial port with a baud rate of //9600// (or //1337// in the first prototypes). |
* Send 'a' to get back an overview of the current setup. | * Send 'a' to get back an overview of the current setup. | ||